Overview
Forum
Mango
iMango
Papaya
Multi-image Analysis GUI
Board Index
Register
Login
Logout
Settings

Surface Resolution

Questions or comments about Mango, webMango, iMango or Papaya.

Moderator: Michael Martinez

Surface Resolution

Postby bryanwong88 » Tue Feb 06, 2018 3:54 pm

Hello all,

This is my first post here. I was able to figure out how to build a 3D surface mesh from MRI.gii, however the resolution of the exterior surface of the brain is very smooth and unresolved (attached example below). As a result the gyri and sulci are indistinguishable. Is there a certain parameter that I can adjust to achieve a higher resolution? When I increase the Min Thresh past 1300.0, there is an error sign that pops up.

My current build settings were:

Min Thresh: 900.0
Shrink Wrap: Yes
Image Smoothing: Width=2.0; Kernel=3
Resolution: X=0.4 Y=0.4 Z=0.4
Surface Smoothing: Error= 0.08; Angle= 44.0 degrees ; Iterations=1
Build Time: 99.92 sec
Points= 1416545; Triangles= 2844148
Attachments
Screen Shot 2018-02-06 at 2.47.53 PM.png
Example of brain
Screen Shot 2018-02-06 at 2.47.53 PM.png (133.08 KiB) Viewed 12840 times
bryanwong88
 
Posts: 1
Joined: Tue Feb 06, 2018 3:31 pm

Re: Surface Resolution

Postby admin » Sun Mar 04, 2018 5:19 pm

Raising the threshold is the best way to see more definition. If you got an error message with a certain threshold it might be because you raised it too high resulting in no data left to build the surface on.
admin
Site Admin
 
Posts: 77
Joined: Fri Jul 06, 2007 8:18 am
Location: Research Imaging Center


Return to Mango

Who is online

Users browsing this forum: No registered users and 1 guest

cron